Page 273

Metallics Distributor Catalog 2014

I TOOLS, DRILLS AND ACCESSORIES LAGMASTER PLUS™ Drive it Home. (socket plugs) Install pre-cut threaded rod from the floor! Works with 3/8" or 1/4" threaded rod up to 10' long. Gets into tight spaces, vaulted ceilings, above stairwells or through ceiling grid easily. Lagmaster Plus™ open-end socket plug-in heads work with Sammy Super Screws® and HangerMate®screws. Special twist out feature prevents over torquing and stripout even when installing from the floor. Hang Threaded Rod: Adjust pole tool to length plug in the proper Lagmaster Plus™ head. Install screw at proper site and pull down to remove the rod from the pole tool. The rod is now ready to receive hanger bracket. Cut threaded rod length and assemble to appropriate fastener. Load rod into Lagmaster pole tool. (The Lagmaster adjusting pin has to be 1/8" below the base or the pin may interfere with the rod.) Consult the screw manufacturer's literature for load specs and approvals on the screws. The Lagmaster Plus™ base is the socket for Hanger- Mate® 3/8" rod screws. The 3/8" socket plug-in works with HangerMate® 1/4" rod screws. The 5/8" socket plug-in works with Sammy Super Screws®. Turn your pole tool into a very long screwdriver. This Lagmaster Plus™ plug works with any 1/4" hex driver. Install smooth rod with a Minerallac™ or Caddy™ spring clip assembly and screw. The Flash fastener is shown here. Overhead Screw Applications: (1/4" hex plug) Plug in the Lagmaster Plus™ 1/4" hex head and insert the proper 1/4" driver. Adjust the Lagmaster pole tool to length. Push the smooth rod between the pole and the wire Turn in the screw cautiously bale on the Lagmaster adjusting pin to keep the rod from whipping while turning in the screw for safety. being careful not to over torque or strip the screw. Remove the tool. 274 www.metallicsonline.com (Patent # 5,154,104)


Metallics Distributor Catalog 2014
To see the actual publication please follow the link above